Guides
Printer guides
Klipper tools for tuning a 3D printer's motion. Two driver tuners write the TMC settings for your motor and board, the simulation runs your G-code through them to show where a print would struggle, and the extruder guide calibrates how much filament goes in.
- TMC2209UART tuner
TMC2209 chopper calculator
Pick your stepper motor, supply voltage, and driver board, and get a ready [tmc2209] block for printer.cfg: run current from the motor rating, StealthChop or SpreadCycle, and chopper timing worked out for that motor. Tell it about growl, screech, or stutter and it adjusts. Paste your current config to see what changes.
BTT TMC2209, EZ2209, EBB36 and EBB42 toolheads, 2226, 2208, and 2240, plus Mellow Fly 2209 and 2240.
TMC2209BTTMellow2240Open - TMC5160SPI tuner
TMC5160 chopper calculator
The same tuner for SPI drivers at 24, 36, 48, or 60 V, checked against each board's voltage rating. It sets run current from the motor rating, matches the chopper timing to your board's sense resistor, and works out the StealthChop speed for your supply voltage. Describe a noise or a stutter and it adjusts, and a pasted config shows what changes.
BTT 5160 V1.0, Pro, EZ5160 Pro, EZ5160 RGB, and Plus, plus Mellow Fly 5160 HV, Pro, and Plus. The RGB uses 0.050 ohm, the BTT Pro 0.075 ohm, and the Fly Plus 0.033 ohm.
TMC5160BTTMellow60 VOpen - SimulationG-code run
TMC simulation
Load an OrcaSlicer G-code file, or a built-in test pattern, and run it through a Klipper-style planner with your motors, belts, and limits. See torque margin, belt slack, ringing, and driver heat for every motor, the speed and acceleration the printer can really hold, and the move where it would skip steps.
Open to everyone. The Simulation role saves printers and runs. Motion lab adds PDF reports and run comparison.
G-codeTorqueBeltsInput shaperOpen - Extruderrotation_distance
Extruder rotation distance
Mark the filament, extrude 100 mm, and measure what is left. It works out how much filament really went in, says whether the extruder is under or over-extruding, and gives the corrected rotation_distance with the test G-code and the line to paste into printer.cfg.
Run it after you change the extruder, the drive gears, or the stepper, before you tune flow in the slicer.
rotation_distance100 mmcalipersOpen