TMC2209, 2226, 2240, and 2208 guide

Chopper settings for TMC2209, TMC2226, TMC2240, and TMC2208.

  • The plugin writes CoolStep (SEMIN 2). Load changes then feel like a stutter or a thump. This page sets SEMIN to 0.
  • It often applies the full rated current. This page starts run current at 80% of RMS: peak rating times 0.707 times 0.80. A 2.5 A motor starts at 1.41 A instead of its full 1.77 A RMS, so it runs cooler.
  • At 36, 48, or 60 V the plugin still estimates stealthChop speed with a 24 V gradient. PWM_GRAD on this page uses the voltage you picked, and PWM_AUTOGRAD stays off so that number is the one that runs.
  • Klipper says a mid-move handoff from StealthChop to SpreadCycle gives poor results. Picking StealthChop keeps it on (threshold 999999), including on X and Y. Both leaves X and Y in SpreadCycle and hands Z and the extruder off at 100 mm/s. Thump turns that handoff off.
  • hold_current is left out of the block. Klipper: dropping current when the motor stops can shift the axis. A falling Z is the exception.
  • The raw hysteresis estimate is a ceiling. Quiet eases it when the coils can take a longer blank. Short coils at 48 V and 60 V stay on TBL 0, because a longer blank does not fit. Growl raises TBL by one and drops HSTRT.

Reset this guide?

This clears the motor, the driver, the pasted config, and the tuning on this page.

Belt tone 110 Hz

Select a motor, a supply, and a driver first.

1001k10k110 Hz

Pluck the open span. Spectroid should peak near 110 Hz. At 100 mm/s the full-step tone is 500 Hz, and the coil sine is 125 Hz. The chopper frequency appears after a motor, a supply, and a driver are set. The rotor and the coil trace run at the real move speed. One coil sine is four full steps.

Motor

Supply and driver

Looking for a TMC5160, 2160, or 2130? Open the TMC51XX calculator.

BTT

Mellow

Config

This is experimental. Verify these settings before you use them. Do not run a driver at the motor's maximum current.

Chopper tuner

2209 · 2226 · 2240 · 2208

Loading driver tables

Click or press Esc to skip